USB BLASTER NOT SHOWING UP IN PROGRAMMER DRIVER
Note that the driver files came with v7.2 is different from v12.0. Click to continue.ĩ- Open Quartus v12.0 and go to toold->programmer->hardware_setup and you will see USB_blaster.ġ0- Don't forget to turn off windows test mode.
USB BLASTER NOT SHOWING UP IN PROGRAMMER UPDATE
See the steps here.ĥ- Open device manager and then power on the board (mine is DE0).Ħ- You will see that USB blaster is listed but it shown as other devices.ħ- Try to update the driver by navigating to C:\altera\72\quartus\drivers\usb-blaster and make sure you have checked "include subfolders".Ĩ- You will see unsigned warning. So, here are the procedures that worked for me:Ĥ- Enter Windows 10 test mode. But it doesn't show any warning even if you enter TEST mode of Windows 10.Īnother thing is that the driver came with Quartus v7.2 is a good one.
unused, Altera FPGA CPLD USB Blaster programmer JTAG Download. The indication is that they are not signed files and windows should warn about that. See all condition definitions Brand: Unbranded/Generic MPN: Does not apply. Important thing to note is I found out that the driver files came with v12.0 (which I tried to use at that time) are not working with Windows 10. However, Quartus has stopped supporting Cyclone III from v14.0 and we want to use windows 10. /rebates/2fitm2f264027340006&252fitm252f26402734000626tc3dbing-&idebay&nameEbay&ra1. I still have a DE0 board which uses Cyclone III and no matter how old it is, it works perfectly.
The DE2 board appears in my Quartus Programmer and I can download the logic to the board.Īlthough the thread is rather old, but this problem exists with some of Altera's product. I reinstalled and ran the program this time with admin privileges and antivirus turned off and then it worked. Why can't it work? From the command-line I can run a tool named jtagconfig that actually seems to find the board but this is from the command line: I reinstalled the drivers, reinstalled Quartus II different versions many times, reset the board, tried both the Quartus version from the CD and from the internet, I see many other people have the same problem with the same board, thank you Altera for making us lose valuable time wasting our time on faulty software. Im not sure how it compares to the real products as far as speed, but it did seem kind of slow when programming the OX2 board Ive got. Below Ive added a dump of what all of the vendor and device IDs that is is showing up. What can be done? The instructions I have are available here. Basically you plug it in then press the only button and it changes what USB device it is. JTAG chain no matter what ( yes even after adding pull up-down resistors as. I use Quartus II web edition and using that driver my computer can find the card:Īnd the card appears in the device manager so it indeed looks correct so far.īut when I start Quartus Programmer to download my logic to the board, the hardware part of the interface is blank where I expect to see my card: Buy Waveshare USB Blaster Download Programming Cable ALTERA FPGA CPLD USB.